|
|
 BELCOMFORT technicians come to your house with a checklist as detailed as an airline pilot’s. Your safety and your comfort are at stake, so they look into all the details. It’s a thorough inspection and no details are left behind. |
 Close inspection of heating equipment uncovers leaks, soot, rust, rot, corroded electrical contacts and frayed wires. Furnace and boilers system inspections also include the chimney, ductwork or pipes, dampers or valves, blower or pump, registers or radiators. |
 The fuel line and gas meter or oil tank also get attention as well as every part of the furnace or boiler itself. The technician will run the system through a complete cycle to make sure there is the right amount of combustion air and draft. He will also check air quality for carbon monoxide. |
 Cleaning the burner and heat exchanger gets rid of the soot and gunk that builds up and impedes efficient operation. Inspecting the fuel flow and adjusting the flame gets you the maximum heat from your fuel. |
 For heat pumps, technicians check the compressor, fan, indoor and outdoor coils, refrigerant lines, and all related components to the heat pump. They clean the coils and check the pressure of the refrigerant. |
 Blowers get the same detailed attention. Axles are lubricated, blades cleaned, lower motor inspected to make sure the unit isn’t being overloaded. |
 Fan belts are adjusted and replaced if necessary. Insulation on accessible ducts in unheated spaces is thoroughly inspected. |
 Technicians drain expansion tanks in hot water systems, clean and lubricate the circulating pump, and bleed air out of radiators. |
 Thermostats are also inspected, cleaned and calibrated. All in all it’s a big job... but well worth it for your peace of mind and the life of your heating and air conditioning systems. |
